Newton T-DAR T1010MT, Инструкция по установке и эксплуатации

Страница: 103 / 112

96
I100 Door Position Encoder
A high resolution door position sensor provides digital-quadrature data to
determine door position, with respect to the overhead stereo cameras. The
Door Position Encoder is used on an inward swinging public door only. If
inward swinging double doors are used at the public entrance two encoders
will be required.
To install the Door Position Encoder use a straight thru Cat-5 with a RJ-45
connector on the encoder end and flying leads at the T-DAR Control Unit. The
leads from the Cat-5 will connect to the D connector on the TDAR Control
Unit as shown in the diagram below.
Jumper Input Common (D7) to +12VDC (D10)
Pins Portal 2; Connector D
5 Input 13 Bl/Wh Blue CAT-5
6 Input 14 Gr/Wh Blue CAT-5
10 +12 Volt Br,Br/Wh Blue CAT-5 +Encoder
12 Ground Or,Or/Wh,Gr,Bl Blue CAT-5 - Encoder
Figure 38
–pin out for encoder Cat-5
Figure 39
–Position of Encoder (Public door only)