Newton T-DAR T1010MT, Инструкция по установке и эксплуатации, Страница: 52 / 112

45
CONNECTION TO LAPTOP / LAN
To Configure the Host TCP/IP Connection
1. The factory set TCP/IP connection on the host computer is typically set to
“automatic”. Changing these settings will establish a connection to the
Newton Security Inc. TDAR, but may disconnect or even conflict with your
current network system. Please check with your network administrator if you
have any questions.
2.
From the desktop right click “My Network Places” and select “Properties”. A
new window will open, select “Local Area Connection” and click “Properties”
from the new selection.
A third window will open, select “Internet Protocol”
(TCP-
IP) and click its “Properties”.
3.
You will see a selection box labeled “Use Following IP Address, select this
option.
4. Enter the following information according to the IP on the T-DAR door:
a. IP: 10.3.10.XX (if XX is .152, then use .153, etc)
b. Subnet: 255.255.255.0
c. Gateway 10.0.0.1 (this may be left blank)
5. Apply these changes and return to the desktop. You may have to reboot your
host computer before the changes take effect. The system will now connect
using the
Configure Connection option in the User Interface.
6. Test the connection . Using a crossover cable for direct connection or
straight through cable on a network, ping the unit by typing “ping –t
10.3.10.152” (use the IP on the door of the control unit).
Install the Software
The Newton Security Inc. T-DAR System Software CD-ROM contains an installer for
the user interface application and a loader program for the T-DAR Control Unit
application. These applications are contained on disks included with the T-DAR
system. T-DAR systems are shipped with the Control Unit application preinstalled.
The included Control Unit install disk may be used for backup purposes.
User Interface (UI) Application
1. Insert the T-DAR Software CD-ROM into the host PC.
2. Browse to the CD-ROM drive and execute setup.exe.
3. Follow the on-screen instructions.