NewMar Mountain Aire 2022, Руководство пользователя

Страница: 123 / 222

© 2021 Copyright Newmar Corporation. All rights reserved. For the most up-to-date version of this content, and for more product-specific information, please refer to Newgle.
118
ENTERTAINMENT SYSTEMS
Winegard Rayzar Automatic Antenna Operation
(Models: RZ-7500, RZ-7535, RZ-8500, RZ-8535)
This article provides information about the control panel, cable and antenna mode, and the automatic search function of
a Winegard Rayzar Automatic Antenna (Models: RZ-7500, RZ-7535, RZ-8500, RZ-8535).
Source(s): Winegard Rayzar Automatic Antenna User Guide
Product(s): This source is associated with more than one product.
Refer to Newgle for more information about the product(s) offered for
your coach’s model year.
Control Panel
Coaches equipped with a Rayzar Automatic Antenna will
also be equipped with a control panel in the overhead
cabinet.
Cable Mode
When the control panel is powered off, park cable
signals will be passed to the TV. In this mode all LEDs
are turned off.
Antenna Mode
When the Control panel is powered on by pressing the
On/Off button, the LEDs will flash and begin its power on
process. At this time the antenna amplifier is powered on
and TV antenna signals will be passed. Initially, GREEN
“Positional LED(s)” will be lit to indicate the direction the
antenna is positioned.
Automatic Search Function
The system does not move until the Search button is
pressed. Channels will be received whenever the system
is powered on.
To begin a new search, press the Search button. The
antenna will go through its initialization process and
begin searching for TV frequencies. A typical search
will take 2-3 minutes. A RED LED will quickly cycle
through the positional LED position to indicate the
antenna is moving and direction it is moving. After the
search is complete, the antenna will automatically go
to the position which results in the most watchable TV
channels. The 2-digit display will show the number of
frequencies seen at that position, and both the GREEN
and RED LED(s) will be lit to indicate the successful
search location.
Additional RED LEDs will also light to show any other
channels found at alternate positions. Pressing the
Search button again will move the antenna to the next
best location. Continuing to press Search again will
cycle through other positions that provided additional
channels, until returning to the main search location. To
clear search results and initiate a new search, press and
hold the Search button for 2 seconds. The system will
also clear all search results each time it is powered off.
2. Make sure the coax cable from the park cable
hookup to the basement of the coach is in good,
working condition and does not have a shorted
shield wire.
3. Each TV will need to be set for cable and auto
programmed at each new campsite location.
4. Any further troubleshooting and diagnosis should be
performed by an authorized service technician.
Winegard RoadTrip T4 Automatic In-Motion Satellite
Operation (Model: RTT-20B/RT2000T)
This article provides basic operation instructions for a Winegard RoadTrip T4 Automatic In-Motion Satellite (Model: RTT-
20B/RT2000T).
1. Turn on receiver and television set. The RoadTrip®
T4 antenna must be connected to a receiver
plugged into 120VAC.
2. Verify that you are getting the receiver’s menu
screens on the television. These screens are
available with or without the dish finding the signal.
3. Ensure receiver is properly configured for your
provider.
Operating The Roadtrip® T4
Antenna