New Holland 200 Series, Руководство оператора

Страница: 42 / 292

2 - SAFETY INFORMATION
No engine power - loader arm up and down control
DANGER
Crushing hazard!
Do not enter or exit the operator's compartment while the loader arms are raised or unsupported. Rest
the loader arms on the ground or verify that loader arm is being supported by the loader arm strut or
loader arm lock pin before entering or exiting the operator's compartment.
Failure to comply will result in death or serious injury.
D0168A
NOTE: The override control knob is for service and emer-
gency situations only and should not be used in day-to-
day operations.
In the event of the loss of engine power, the override con-
trol knob will allow the operator to raise or lower the loader
arm. See the decal on the override control knob
(1) (red
control knob on the right-hand side of the operator’s seat).
Before attempting to raise or lower the loader arm/attach-
ment on a machine that has lost engine power, alert per-
sonnel in the area of your intention. Do not leave the
seat, or unfasten the seat belt or raise the restraint bar
(if equipped).
To lower the loader arm/attachment:
1. Confirm that personnel and obstacles are clear.
2. Pull the override control knob UP. The loader arm/at-
tachment will start to lower.
48061698A
1
3. To stop the loader arm/attachment from lowering,
press the control knob DOWN at any time.
4. Once the loader arm/attachment is safely supported
on the ground or on the loader arm lock support, make
sure that the override control knob is completely in the
DOWN position.
To raise the loader arm/attachment:
1. Have an assistant attach a secondary external lifting
device to the front of the loader arm.
NOTICE: Do not attempt to move or lift the machine
while raising the loader arms. You may damage the
loader arm or attachment.
2. Confirm that personnel and obstacles are clear.
3. Pull the override control knob UP while the assistant
raises the secondary external lifting device.
93107465A
2
4. Engage the loader arm lock as shown on “Loader arm
lock and cab tilt procedure - radial lift machines” 2-18
or “Loader arm lock and cab tilt procedure - vertical lift
machines”
2-22 .
5. Press the override control knob DOWN before discon-
necting the external lifting device.
2-26