New Holland 200 Series, Руководство оператора

Страница: 142 / 292

5 - TRANSPORT OPERATIONS
You must know the rules or laws for safety that are used
in each area that you will be in. Make sure that your truck
and machine are equipped with the correct safety equip-
ment.
Load the machine on to a trailer:
1. Put a chock block to the front and rear of all trailer
wheels.
2. Use low idle speed, move the skid steer slowly onto
the trailer. Keep the machine in the center of the ramp
and trailer.
3. Lower the bucket or attachments onto the trailer. Make
sure not to lift the front of the machine off the trailer.
4. Shut the engine off.
5. If applicable, remove the key.
NOTE: Small frame units should route the strap as
the top image shows. Medium and large frame units
should route the strap as the third image shows,
through the hand holds or use the key hole available
on the lift arm stops.
6. Use straps to fasten the skid steer to the trailer. Only
use the tie-down locations, in the front and rear iden-
tified with the tie-down decal.
7. Put chock blocks at both ends of the wheels or tracks
of the machine.
8. Remove the chock blocks from the trailer wheels.
Unload the machine from a trailer:
1. Put a chock block to the front and rear of all trailer
wheels.
2. Remove the tie down straps.
3. Remove the chock blocks at both ends of the wheels
or tracks of the machine.
4. Start the machine and keep at a low idle speed.
5. Drive slowly down the center of the trailer or ramps.
93109388
1
93109385
2
93109386B
3
5-2