New Holland 200 Series, Руководство оператора

Страница: 131 / 292

4 - OPERATING INSTRUCTIONS
4 - OPERATING INSTRUCTIONS ###_4_###
COMMISSIONING THE UNIT
Operating Instructions
Before each operating period, it is the responsibility of the operator to confirm that the
machine is safe and serviced.
During the first 20 h of operation, make sure to do the
following:
1. If possible, operate the engine at intermittent heavy
loads and engine speeds for this period to ensure
proper engine break-in.
2. Keep the engine at normal operating temperature.
3. Do not run the engine at idle speeds for long periods
of time.
4. During the first 20 h break-in period, check the oil level
at approximately 1 h intervals. Oil consumption may
be higher during the initial break-in period.
5. It is recommended that the operator run the engine at
full throttle when operating conditions permit.
NOTICE: After the first 50 h of operation, change the en-
gine oil and filter.
Wheel bolts
If the machine is new or if a wheel is removed for service, check and tighten the wheel bolts every 2 h of operation
until they remain tight. If the machine is equipped with stamped center wheels, the lug nuts will be tapered. Tighten
each lug nut to a torque of
162.7 – 196.6 N·m ( 120 – 145 lb ft ).
If the machine is equipped with solid center wheels, the lug nuts will be flanged. Tighten each lug nut to a torque of,
189.8 – 223.7 N·m ( 140 – 165 lb ft ).
63109344
1
4-1