New Holland 200 Series, Руководство оператора

Страница: 159 / 292

6 - WORKING OPERATIONS
Installing the attachment
1. Confirm the red markings on the indicator pins (2) are
visible (unlock position). If the red markings are not
visible, press and hold the hydraulic coupler switch
(1)
in the unlock direction. With the other hand activate
and hold the control lever’s auxiliary switch.
2. Tilt the hydraulic coupler forward.
3. Slowly move the machine toward the attachment until
both tabs on top of the coupler are underneath and in
alignment with the attachment’s mounting points.
4. Raise the loader arm enough to engage the attach-
ment.
5. Curl the coupler back towards the machine until the
attachment is completely resting on the coupler and
off the ground.
NOTE: In the next step, if the indicator pins do not
retract you may need to reposition the attachment on
the coupler.
6. Activate the auxiliary switch on the control lever to the
end of its control stroke. The indicator pins (2) on the
coupler will retract into the lock position and the red
markings will no longer be visible on the indicator pins.
7. Slowly raise and roll the attachment outward. Do not
leave the operator seat but make a visual inspection
from the cab that the hydraulic coupler’s lower lock
pins
(1) extend fully into the attachment’s lower tab
slots.
WARNING
Falling object hazard!
Before operating the machine, always make
sure the bucket or attachment is securely
locked into the coupler. A loader bucket or
attachment that is not securely locked into
the coupler could come off during loader op-
eration.
Failure to comply could result in death or se-
rious injury.
W0947A
93106917
3
93106837A
4
86092926
5
8. Make sure that the attachment is secure and safe to
use. Operate the attachment through the full range of
motions before you begin normal work operations.
6-5