Netscout OneTouch AT 10G, Руководство пользователя

Страница: 123 / 248

Chapter 5: User Tests
10G Wired Performance Test (Y.1564)
121

Configure:

- The OptiView XG must be configured to allow Remote
UI connections.

- Note whether the OptiView XG has encryption and user
accounts enabled. You will need this information for the
OneTouch AT 10G configuration.

- IF the OptiView XG has user accounts enabled, the user
account on OptiView XG must be configured to allow
Remote UI and Performance Tests.

Results/File Management: The test causes a new test suite
to be created and/or overwritten on the OptiView XG. See
"How it Works" on
page 122 to learn more.

Ports and Firewalls: The following ports must be open in
firewalls between the OneTouch and the OptiView XG:

- TCP port 1695.

- UDP port number to match the Port value set on the
OneTouch and OptiView XG. The default is 3842.
2
Connect AC power to the OneTouch AT 10G analyzer. This
ensures that the unit will not run out of battery power, and
will not automatically power-down if a Timeout Period is set.
3
On the OneTouch AT 10G, press and hold one of the test tiers
to open the ADD TEST screen. Tap the 10G Wired Performance
(Y.1564) test.
4
Set the test parameters described in the previous section. In
particular, you will set
Use OptiView XG Test Suite to Off if you
want to create a new simple performance test, or On if you
want to run a more complex performance test suite that
already exists on the OptiView XG.
5
Run the test individually or as part of a test profile. See "Run
the Test" on
page 122 to learn more. Link will automatically
be established if you have not yet run AutoTest (which
establishes link). It may take up to a minute to establish link.
6
Tap the Results tab when the test is finished to see test results.
Go to "Results" on
page 123 to learn more.