Netscout OneTouch AT 10G, Руководство пользователя

Страница: 110 / 248

OneTouch AT 10G
User Manual
108
3
Select the configuration values in the SETUP tab of the test. In
particular, set the
Type
value to Peer. See "SETUP Parameters"
on page 103 for definitions of configuration parameters.
4
Run the test individually or as part of a test profile. See "Run
the Test" on
page 110 for more information.
Test results are described in "Results" on page 110 .
To Configure a LinkRunner 2000 as a Reflector
You can configure the LinkRunner AT 2000 as a reflector for
OneTouch AT 10G.
Note
The LinkRunner AT 2000 Reflector feature only
operates on a full duplex link.
1
Connect the AC adapter to the LinkRunner AT 2000 or ensure
that the battery has enough charge to complete the test.
2
On the LinkRunner AT 2000 home screen, select Tools .
3
Select General Configuration .
4
Under the Manage Power section, ensure that the Auto
Shutoff Enabled check box is unchecked. This will prevent the
LinkRunner from powering down while reflecting traffic.
5
Select Save .
6
In the Tools menu, select Reflector . The tester will acquire an
IP address. Note the IP address. You will enter this address
when setting up the source analyzer.
If the tester does not acquire an IP address, go to the Tools >
IP Configuration screen and verify that DHCP has been selected