Copyright © NetPing east Co., Ltd E-mail:
Phone:+886-2-23121582
[ENG] 10.6. [DKSF 48.4 IU] Reset Signal and Initial Statuses of Outputs
When firmware starts operation or when clicking the button «
» at the page «
» of a device web interface, outputs, controlled by the logic
Reset
LOGIC
are set to the known initial status. On default, this status is «
», or «
». Other statuses can be set using the rule at the page «
», which uses
off
logic 0
LOGIC
a reset signal «
» at the input.
RESET
5 seconds after a reset, the signal has the value «
». A rule with a condition «
» works in the moment of reset. A rule with a condition «
»
logic 1
= 1
= 0
works 5 seconds after the moment of reset. Therefore, it is possible to form a 5-second external reset pulse at one or several outputs or provide a proper
sequence of a power supply to the external devices.
If a logic operation is stopped, the rules «
», which correspond to completion of the signal «
», will work after clicking the
If/while RESET = 0
RESET
control button «
» at the page «
» of a device web interface.
Start
LOGIC
