Switching Commands
173
ProSafe Managed Switch
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Format
no lldp receive
Mode
lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled
for LLDP. The
<interval-seconds>
determines the number of seconds to wait between
transmitting local data LLDPDUs. The range is 1-32768 seconds. The
<hold-value>
is the
multiplier on the transmit interval that sets the TTL in local data LLDPDUs. The multiplier
range is 2-10. The
<reinit-seconds>
is the delay before re-initialization, and the range is
1-0 seconds.
Default
• interval—30 seconds
• hold—4
• reinit—2 seconds
Format
lldp timers
[interval <interval-seconds>] [hold <hold-value>] [reinit
<reinit-seconds>
]
Mode
no lldp timers
Use this command to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Format
no lldp timers
[interval] [hold] [reinit]
Mode
lldp transmit-tlv
Use this command to specify which optional type length values (TLVs) in the 802.1AB basic
management set are transmitted in the LLDPDUs. Use
sys-name
to transmit the system
name TLV. To configure the system name, see
snmp-server
on page
661. Use
sys-desc
to
transmit the system description TLV. Use
sys-cap
to transmit the system capabilities TLV.
Use
port-desc
to transmit the port description TLV. To configure the port description, see
description
on page
23
Default
Format
lldp transmit-tlv
[sys-desc] [sys-name] [sys-cap] [port-desc]
Mode
Interface Config
Global Config
Global Config
all optional TLVs are included
Interface Config
