Management Commands
689
ProSafe Managed Switch
Configuration Scripting Commands
Configuration Scripting allows you to generate text-formatted script files representing the
current configuration of a system. You can upload these configuration script files to a PC or
UNIX system and edit them. Then, you can download the edited files to the system and apply
the new configuration. You can apply configuration scripts to one or more switches with no or
minor modifications.
Use the
show running-config
command (see
show running-config
on page
525) to
capture the running configuration into a script. Use the
copy
command (see
copy
on
page
547) to transfer the configuration script to or from the switch.
You should use scripts on systems with default configuration; however, you are not prevented
from applying scripts on systems with non-default configurations.
Scripts must conform to the following rules:
•
Script files are not distributed across the stack, and only live in the unit that is the master
unit at the time of the file download.
•
The file extension must be “.scr”.
•
A maximum of ten scripts are allowed on the switch.
•
The combined size of all script files on the switch shall not exceed 2048 KB.
•
The maximum number of configuration file command lines is 2000.
You can type single-line annotations at the command prompt to use when you write test or
configuration scripts to improve script readability. The exclamation point (!) character flags
the beginning of a comment. The comment flag character can begin a word anywhere on the
command line, and all input following this character is ignored. Any command line that begins
with the “!” character is recognized as a comment line and ignored by the parser.
The following lines show an example of a script:
! Script file for displaying management access
show telnet !Displays the information about remote connections
! Display information about direct connections
show serial
! End of the script file!
Note:
To specify a blank password for a user in the configuration script,
you must specify it as a space within quotes. For example, to
change the password for user
jane
from a blank password to
hello
, the script entry is as follows:
users passwd jane
" "
