Utility Commands
591
ProSafe Managed Switch
Rip_Version: RIPv2 Packet_Type:RIP_RESPONSE
ROUTE 1): Network: 10.1.1.0 Mask: 255.255.255.0 Metric: 1
ROUTE 2): Network: 40.1.0.0 Mask: 255.255.0.0 Metric: 1
ROUTE 3): Network: 10.50.50.0 Mask: 255.255.255.0 Metric: 1
ROUTE 4): Network: 41.1.0.0 Mask: 255.255.0.0 Metric: 1
ROUTE 5): Network:42.0.0.0 Mask:255.0.0.0 Metric:1
Another 6 routes present in packet not displayed.
The following parameters are displayed in the trace message:
TX/RX
Intf
Src_IP
Dest_IP
Rip_Version
Packet_Type
Routes
Number of
routes not
printed
no debug rip packet
This command disables tracing of RIP requests and responses.
Format
no debug rip packet
Mode
debug sflow packet
Use this command to enable sFlow debug packet trace.
Default
Format
debug sflow packet
Mode
Parameter
Definition
TX refers to a packet transmitted by the device. RX refers to packets received by the
device.
The interface that the packet came in or went out on. Format used is unit/slot/port
(internal interface number). Unit is always shown as 1 for interfaces on a non-stacking
device.
The source IP address in the IP header of the packet.
The destination IP address in the IP header of the packet.
RIP version used <RIPv1 or RIPv2>.
Type of RIP packet. <RIP_REQUEST or RIP_RESPONSE>.
Up to 5 routes in the packet are displayed in the following format:
Network: <a.b.c.d> Mask <a.b.c.d> Next_Hop <a.b.c.d> Metric <a>
The next hop is only displayed if it is different from
0.0.0.0
.
For RIPv1 packets, Mask is always
0.0.0.0
.
Only the first five routes present in the packet are included in the trace. There is another
notification of the number of additional routes present in the packet that were not
included in the trace.
Privileged EXEC
disabled
Privileged EXEC
