Managed Switch CLI Manual, Release 8.0
Management Commands
7-5
v1.0, July 2009
network protocol
This command specifies the network configuration protocol to be used. If you modify this value,
change is effective immediately. If you use the
bootp
parameter, the switch periodically sends
requests to a BootP server until a response is received. If you use the
dhcp
parameter, the switch
periodically sends requests to a DHCP server until a response is received. If you use the
none
parameter, you must configure the network information for the switch manually.
network mac-address
This command sets locally administered MAC addresses. The following rules apply:
•
Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered
(b'0') or locally administered (b'1').
•
Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual
address (b'0') or a group address (b'1').
•
The second character, of the twelve character macaddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
network mac-type
This command specifies whether the switch uses the burned in MAC address or the locally-
administered MAC address.
Default
none
Format
network protocol
{none | bootp | dhcp}
Mode
Privileged EXEC
Format
network mac-address
<macaddr>
Mode
Privileged EXEC
Default
burnedin
Format
network mac-type
{local | burnedin}
Mode
Privileged EXEC
Содержание FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Страница 4: ...v1 0 July 2009 iv...
