Net To Net Technologies SIA2410R User Manual
Net To Net Technologies
55
Configuration example
Connect LAN port on the SIA2410R router to your PC(TFTP Server) using UTP straight-
through cable.
1>
Configure “192.168.1.1/255.255.255.0” IP address on your router.
2>
Configure “192.168.1.2/255.255.255.0” IP address on your PC.
3>
Make sure the MS-DOS window is running on your PC, execute the ping command.
C:\> ping 192.168.1.1
Verify whether it receives a response.
4>
Make sure the TFTP server is running and place the Firmware file in your TFTP
server’s root directory.
5>
Enter the following commands to the SIA2410R router :
(conf)# tftp 192.168.1.2 sia2410r_3_9_2.bin
downloads sia2410r_3_9_2.bin into the router from a TFTP server's IP address of
192.168.1.2
(conf)# write config
save the current configuration to Flash memory.
(conf)# reboot tftp
reboots your router to load downloaded new firmware.
(conf)# write tftp
saves the downloaded new firmware to Flash memory.
image checksum OK
WARNING !!! this may crash your system, check again:
boot image information:
- image start : 0x380000
- image end : 0x3cf995
- image size : 326037(0x4f995) bytes
Confirm ? (y/n)
“y”
writing boot image ...
verify OK
(conf)#
The following command displays both the version of the firmware currently stored in
Flash memory and the version of the firmware currently running in memory(DRAM).
(conf)# show version
System Software Release:
3.7.13
[Mon Jan 28 10:16:20 2002] running
new version
3.7.13 [
Mon Jan 28 10:16:20 2002] saved
new version
SIA2x10R
192.168.1.1
LA N
LA N
TFTP Server
192.168.1.2
