Net To Net Technologies SIA2410R User Manual
Net To Net Technologies
35
Setting up Bridging-Only Mode
As described above, setting the bridge mode without deleting the
routing mode from the interface will trigger a setup of "Routing and
Bridging Mode". To set a mode to "Bridging-Only Mode", the routing
mode must be deleted.
Command
interface
<ifname>
bridge enable
ip routing disable
<ifname>
Confirmation of
Setup
(conf)# sh int
: Confirm "Bridging-Only Mode".
Note:
To operate as a bridge, you must configure "Bridging-Only Mode" to all
interfaces(LAN and WAN).
Managing the bridge table
In order to forward bridged packets to the right network destination,
the SIA2410R uses a bridge table that associates end nodes with
particular connections. It builds this table dynamically, in a process
called transparent bridging. The following command shows the
bridge map:
Command
show bridge map
