Net To Net Technologies SIA2410R User Manual
Net To Net Technologies
13
Accessing the Console
Connecting via the Console Port
To configure the router a serial connection needs to be made between the
SIA2410R and a PC. Connect the RJ-45 connector to the port labeled
‘CONSOLE’ on the back of the SIA2410R unit, and the other end of the cable
(DB-9 connector) to the computer’s COM port.
Run any communications program that supports vt100 emulation
(HyperTerminal or Zterm for example) to communicate directly with the
router through the computer’s COM port.
Note:
If random or illegible characters appear on your display, the
communications settings are probably incorrect. Mask sure that your
communications software is configured as follows.
[Table 2-2] Console software parameters
PARAMETER
VALUE
Bits per Second
9600
Data Bits
8
Parity N
Stop Bit
1
Flow Control
None
Terminal Type
VT100
Telnet Connection
Once the SIA2410R has been configured with an IP address, you may use the
IP address to open a Telnet session with the unit from any workstation on the
same network. The Net To Net Technologies SIA2410R can be configured
using a program that supports the Telnet protocol.
