Neco STIR-RITE III, Руководство владельца/оператора

Страница: 20 / 60

INSTALL TROLLEY RETURN CARRIAGE SECURE THE MAIN BEAM
20
Before assembling the trolley return carriage to the
beam, securely fasten the beam to saw horses,
benches, or any other stable device. The beam will
not sit upright on its own - after the Trolley Return Car-
riage assembly, the unbalanced weight will make the
beam want to “roll over”. BEAM MUST BE CLAMPED
The clamps should be placed at both
ends of the beam and on the opposite
side of where the motors will be. Four
clamps may be used .
WARNING
1. Determine “X” dimension to use:
2 - Trolley Units X = 43” (Shown)
3 - Trolley Units X = 67”
4 - Trolley Units X = 91”
2. Secure the return carriage to the beam using four (4)
1/2-13 x 1 1/2”
bolts, lock washers and 1/2-13 nuts
.
NOTE:
Make sure the bolt head flats are turned par-
allel to the edge of beam flange - the trolley wheels
must have proper clearance.
The dimension “X” shown in Figure 7 is the location
used for the FIRST HOLE of the return carriage mount
plate. As an example, Figure 7 shows the dimension
and location for mounting the return carriage when a 2
trolley unit is used.
The Trolley Return Carriage mount plate uses a four-hole
mounting pattern. There are three possible mounting
positions along the beam - dependant upon how many
trolley units are being used on the system.
The drive cluster assembly will mount to the end of
the beam that has the four mounting holes located on
top, allow this end of the beam to extend at least 12”
(305 mm) past the edge of the sawhorse.
Figure 7 - Secure Beam / Attach Trolley Return Carriage
BEAM ASSEMBLY