Neco STIR-RITE III, Руководство владельца/оператора

Страница: 16 / 60

16
PRELIMINARY CONSIDERATIONS
4. ASSEMBLY & INSTALLATION
GATHER TOOLS, IDENTIFY COMPONENTS, ETC.
Before bin assembly, do the following:
• Gather, identify, and sort the Stir-Rite III parts in the center of the concrete pad for ease of
accessibility.
• Locate a pair of sawhorses or similar supports to assemble the beam section on.
• The track is normally positioned 10 1/4” (260 mm) down from the eave of the bin (top of the
top bin sheet) to the center line of the track. Bin roof profiles and / or additional equipment,
such as spreader units, may require different positioning.
• Steeply pitched or domed roofs may allow the 10 1/4” distance to be reduced, while bins with
low or flat profiles may require additional clearance.
• Reinforcements for the roof or roof ladder which may interfere with the movement of the Stir-Rite
III should be trimmed, if this cannot be done, the distance of the 10 1/4” from the eave to the
track bolt center line must be increased proportionately.
• Because the Stir-Rite III auger system runs close to the bin wall, no inside wall ladder can be
used. A portable ladder is advised and can be obtained from your dealer.
DETERMINE SPECIAL CLEARANCE ISSUES
The following circumstances require checking for special clearance issues:
1. Bins less than 21’ diameter or bins with low pitch roofs.
2. Bins that have a spreader installed or plans to install a spreader in the future.
DETERMINE SMALL BIN CLEARANCE - BINS LESS THAN 21’ DIAMETER
POSITION HANGER CHANNEL WITH MINIMAL
CLEARANCE AGAINST ROOF AND VERIFY 49” DIM
TO TRACK C/L WILL ALLOW THE REQUIRED MINI-
MUM DISTANCE.
Also, refer back to Figure 3A
and note the required “1/8” per foot beam rise
toward bin center” that is recommended.