NEC SigmaBlade N8406-040(F), Руководство пользователя

Страница: 17 / 206

For Proper Operation
Observe the following notes for successful operation of the 8G FC Switch.
Use of the 8G FC Switch ignoring the notes will cause malfunctions or failures of the 8G FC Switch.
„
Do not install the 8G FC Switch in any Blade Enclosure (SIGMABLADE) unauthorized by NEC.The
Blade Enclosure that can install the 8G FC Switch is as follows.
SIGMABLADE-M : N8405-016F/016AF
SIGMABLADE-H : N8405-040F
The above-mentioned composition is information as of November, 2010. Contact your service
representative for latest information.
„
The 8G FC Switch is extremely sensitive to static electricity. Make sure to touch the metal frame of
the chassis to discharge static electricity from your body before handling the 8G FC Switch. Do not
touch the 8G FC Switch terminals or onboard parts by a bare hand and place the 8G FC Switch
directly on the desk.
„
Do not drop the product. Do not make the product hit against other objects. Failure to follow these
instructions may cause the product to operate incorrectly or to be damaged.
„
Hold the portions covered with metal plates when the 8G FC Switch is installed or removed. To
carry the 8G FC Switch, put it into the case in which the 8G FC Switch was contained at the
purchase and pack it into the package.
„
Store the unit under the storage condition (temperature: –10 to 55°C, humidity: 20 to 80%, without
condensation) to allow built-in devices and the unit to operate correctly in the next operation.
„
The 8G FC Switch contains precision component that is easily affected by drastic temperature
change. If the 8G FC Switch is used after storage or relocation, make sure that the 8G FC Switch is
fully adapted to the operating environment.
„
If the product cannot be installed in switch module slot of the Blade Enclosure (SIGMABLADE)
securely, remove the product once and then install it again. Adding excess force to the product may
cause the product to be damaged.
„
Do not use a cellular phone or pager around the 8G FC Switch. Turn off the cellular phone or pager.
Radio interference may cause malfunctions of the 8G FC Switch.
- 17 -