NEC SigmaBlade N8406-040(F), Руководство пользователя

Страница: 147 / 206

Information displayed by "switchshow" command
Item Displayed data Description
Port 0 - 23 Correspond to the port numbers of the 8G FC Switch.
-- No SFP+ module is installed on ports (for external ports only).
Cu Media of copper type is installed. (The value is fixed for internal ports).
Media
id An SFP+ module of fibre type is installed.
AN The port data rate is auto negotiated.
4G The port data rate is fixed to 4G bps.
Speed
8G The port data rate is fixed to 8G bps.
N4 The port data rate is auto negotiated to 4G bps.
N8 The port data rate is auto negotiated to 8G bps.
No_Module No SFP+ module is installed.
Online The Fibre channel device is linked up normally.
Either of the following two messages appears in normal linkup status
depending on the port topology of the connected fibre channel device:
"Online F-Port WWN" in fabric connection or
"Online L-Port 1Pubric" in loop connection.
State
The SFP+ module receives optical signals, but the signal is not in
synchronized state. No_Sync
The SFP+ module receives optical signals and the signal is in
In_Sync
synchronized state, but the Fibre channel device is not linked up
normally.
No_light The SFP+ module does not receive optical signals.
Laser_Flt The SFP+ module has output laser Fault.*
Port_Flt The SFP+ port is in fault state.
Diag_Flt The SFP+ port is disabled because of detecting error by self-diagnosis.*
NOTE:
„ You can identify the fault location by comparing the information shown by
"switchshow" command with the actual connection.
IMPORTANT:
„ The state messages for the internal and external ports unavailable to N8406-040 are
"No_Sync Disabled (Persistent)" and "No_Module (No POD License) Disable,"
respectively.
„ A hardware error occurs in each status with asterisk mark (*) in the table above.
Maintenance work is required for recovery. Contact your service representative.
- 147 -