NEC POWERMATE PRO2180 - SERVICE 1996, Руководство по обслуживанию

Страница: 147 / 195

Repair 5-7
Front Panel Assembly Removal
Remove the front panel from the system unit as follows.
1. Remove the system unit cover as previously described (see “System Unit Cover
Removal”).
2.
Disconnect the LED and IR cables on the front panel from the system board. (See
Appendix A for system board connector locations.)
3. Carefully pull on the front panel, releasing the six tabs that secure the panel to the
system chassis (see Figure Section 5-7).
Figure Section 5-7 Removing the Front Panel
4.
Slide the front panel cables through the hole in the chassis.
Blank Panel and Metal Cover Plate Removal
Remove the blank panels and the metal cover plates from the chassis as follows.
1. Remove the front panel as previously described (see “Front Panel Removal”).
2.
Remove the blank panel from the selected slot in the front panel by pressing the
tabs inside the front panel and pushing the blank panel out.
Store the blank panel for possible later reinstallation.
3. Remove the slot cover from the selected slot on the chassis by unscrewing the
screws on each side of the cover (see Figure Section 5-8).