5-18 Repair
Plastic Rail Removal
Use the following steps to remove the plastic rail from the system board:
1.
Remove the system unit cover as previously described.
2.
Remove the system board as previously described.
3.
Place the system board on a level static-free surface.
4.
Remove the two screws that hold the plastic rail to the underside of the system
board (see Figure 5-16).
5.
Lift the system board off the plastic rail.
6.
Lift grounding clips off their notched seats on the plastic rail.
NOTE:
The grounding clips are keyed to fit
correctly on the plastic rail. Make sure the clips
are fully seated on the plastic rail before
attaching the rails to a system board.
Figure 5-16 Removing the System Board Plastic Rail
Содержание PowerMate Enterprise
Страница 76: ...Section 2 Setup and Operation igure 2 2Figure 2 3 Figure 2 4 Figure 2 5 Figure 2 6 Figure 2 7 Figure 2 8 ...
Страница 196: ...Section 5 Repair Figure 5 1Figure 5 2Figure 5 3Figure 5 4Figure 5 5Figure 5 6Figure 5 7 ...
Страница 199: ...5 12 Repair 4 Slide the device out of the front of the system unit Figure 5 10 Removing a 5 1 4 Inch Device ...
Страница 271: ...Index 9 W Wake on LAN connector A 14 enabling 2 25 Z Zip drive 1 29 jumper settings B 7 specifications 1 51 ...
