NEC PowerMate Enterprise, Руководство пользователя

Страница: 36 / 275

Technical Information 1-19
NOTE:
Interrupts used for the built-in parallel
port are not available for ISA parallel ports.
Parallel interface signals are output through the system board’s 25-pin, D-subconnector.
The connector is located at the rear of the system unit. Pin locations for the parallel
interface connector are given in Appendix A.
Serial Interface
The system has two 16C550 UART compatible serial ports (COM1 and COM2) integrated
on the I/O controller. The serial ports support the standard RS-232C interface. The buffered
high-speed serial ports support transfer rates up to 115.2 KB. These ports allow the
installation of high-speed serial devices for faster data transfer rates.
Sets of I/O addresses and interrupt levels for the two channels are given in Table 1-9 and
Table 1-10. (Note that COM2 is disabled by default.) The interrupt levels are selectable via
the BIOS Setup utility and include IRQ3, IRQ4, IRQ10, and IRQ11. Software-selectable
base addresses are 3F8h, 2F8h, 3E8h, and 2E8h. If serial ports are reconfigured to share an
interrupt, verify that the software and hardware added by users can share interrupts without
problems.
NOTE: Any interrupts used for the built-in
serial ports are not available for ISA parallel
ports.
If serial ports share an interrupt, verify that
hardware and software added to the system can
share these interrupts without problems.
Table 1-9 Serial Port 1 Addresses and Interrupts
Starting I/O Address Interrupt Level Port
3F8 IRQ04 COM1
2F8 IRQ03 COM2
3E8 IRQ04 COM3
2E8 IRQ03 COM4
3F8 IRQ03 COM1
2F8 IRQ04 COM2
3E8 IRQ03 COM3
2E8 IRQ04 COM4