28
1
1
2
2
3
3
a
b
c
4
Method 2. Mounting of Highlite Series Lenses
Please see the manual of the lens when mounting Highlite Series lenses.
Note:
When Highlite Series lenses are used, DLP-CINEMA lens level performance will not be obtained.
4-4. Anamorphic Lens Holder Installation
The mounting of an anamorphic lens is required for the iS10.
Anamorphic lenses are available in a 1.5 ratio or a 1.9 ratio.
Please purchase one of these lenses to suit the content of the material that is to be projected.
The projector is equipped with a built-in anamorphic lens mounting shaft for the purpose of mounting an
anamorphic lens. The packaging box of the projector contains the following parts for the purpose of mounting
an anamorphic lens.
• Lens shaft ....................................... 2
• Anamorphic lens holder ................. 1
Installation of the Anamorphic Lens
Fastening Fittings
햲
Remove the lens cover and the rubber cover
of the projector front, then mount the 2 lens
shafts.
햳
Remove the rubber cover from the side of the
projector, loosen the hexagonal screws and pull
out the anamorphic lens mounting shaft as far
as it will go, then temporarily tighten the hex-
agonal screw.
햴
Turn and remove the anamorphic lens mount-
ing shaft end, insert the anamorphic lens
holder, then mount the shaft end that had been
removed.
햵
Fasten the anamorphic lens holder to the lens
shaft so that it does not come in front of the
primary lens until the adjustment of the primary
lens has been completed.
