3-32 Setting Up Your Server
Connection to External SCSI Devices
Two Ultra 320 SCSI connectors are equipped with the baseboard in your server.
Ultra 320 SCSI (A) connector is used to connect the internal SCSI hard disk drives. Ultra 320 SCSI
(B) connector is used to connect the internal 5.25-inch SCSI file device or external SCSI devices.
The internal SCSI cable for 5.25-inch SCSI file device is connected to Ultra 320 SCSI (B)
connector at the factory.
To connect the external SCSI devices with your server, you must change the internal SCSI cable
connection by using the attached external SCSI cable (see Chapter 9 for details).
If your system can connect with the external SCSI devices, observe the following notices. (For notes
on connecting the optional add-in SCSI card, refer to the manual that comes with the optional card.)
Choose the SCSI ID between 0 and 6 that hasn't been assigned to any other SCSI device
connected to your server.
Enable the SCSI termination or connect the SCSI terminator to the device that is at the
end of SCSI chain.
Only one SCSI device can be connected to your server. (A maximum of two devices when
N8141-28AF device expansion unit is connected.)
Use the "SCSISelect" utility to make the setting for the connected SCSI device.
When an external SCSI devices is connected, the device can operate at the transfer rate
shown in the table below depending on the internal line length of the connected device
and the total length of SCSI cables.
Internal line length of
external SCSI device and
total length of SCSI cables
Maximum
transfer rate
[MB/sec]
[Sync Transfer
Rate]
in SCSI
Select
Data transfer
width
20
Auto
*2
Narrow (8-bit)
2 m or shorter
*1
40
Auto
*2
Wide (16-bit)
11 m or shorter
(only for LVD)
320, 160, 80
Auto
*2
Wide (16-bit)
*1 The total length of SCSI cables should be 1 m or shorter if the NB141-28AF device
expansion unit is installed.
*2 The value is set to "Auto" at the shipment. For some SCSI devices, the transfer
rate may be restricted. To install a SCSI device, read the manual coming with the
device carefully.
Содержание Express5800/140Rc-4
