NEC EXPRESS5800/140He, Руководство по обслуживанию

Страница: 164 / 184

- 148 -
9.
Other Notes (Restrictions)
The USB connectors on the front of the Server are applicable only to USB1.1 but not to
USB2.0.
Connect USB2.0 corresponding devices to the USB connectors on the rear of the Server.
Connecting a USB2.0 corresponding device to a USB connector on the front of the Server
may cause an error to occur.
The seamless setup of EXPRESSBUILDER is available only for the onboard RAID
controller.
The seamless setup cannot be used to install OS in a HDD connected to PCI boards
(including Disk Array Controller and SCSI Controller).
Always install OS by using the manual setup.
If the MegaRAID Configuration Utility is started from POST, message "Press <Ctrl>
<M> or <Enter> to Run Config Utility" appears on the screen. However, always press
<Enter>.
Pressing <Ctrl><M> sometimes causes the Ctrl key not to be released, thus disabling
normal key entries. If this should occur, press the Ctrl key again.
Backup devices cannot be connected to the Onboard RAID controller.