NEC Express5800/120Mc2 series, Руководство пользователя

Страница: 36 / 172

2-4 Setting Up the System
Rack-Mount Subsystem Assembly
This section provides the instructions for assembling the rack-mount server unit
into a standard EIA 19 inch rack cabinet.
Before You Begin
Before you begin, please review the following cautions, warnings, and general
guidelines.
! WARNING
Be sure that power to the system is turned off and
unplugged. All voltage is removed only when the power
cords are unplugged.
!
Avoid excessive vibration and shock. Dropping an electronic component
can cause serious damage.
!
Do not disconnect or remove parts other than those specified in the
procedure.
!
Do not touch I/O connector pins.
!
All screws are phillips-head, unless otherwise specified.
!
On completion of any assembly or reassembly, perform a power-on test.
If a fault occurs, verify that the assembly or reassembly was performed
correctly. If the problem persists, see "Problem Solving" in Chapter 5.
Static Precautions
An electrostatic discharge (ESD) can damage disk drives, option boards, and
other components. You can provide some ESD protection by wearing an
antistatic wrist strap attached to chassis ground when handling system
components.
Electronic devices can be easily damaged by static electricity. To prevent
damage, keep them in their protective packaging when they are not installed in
your system.