© National Instruments Corporation
2-1
AT-MIO-64F-5 User Manual
Chapter 2
Configuration and Installation
This chapter explains the board configuration, installation of the AT-MIO-64F-5 into the PC,
signal connections to the AT-MIO-64F-5, and cable considerations.
Board Configuration
The AT-MIO-64F-5 contains one DIP switch to configure the base address selection for the AT
bus interface. The remaining resource selections, such as DMA and interrupt channel selections,
are determined by programming the individual registers in the AT-MIO-64F-5 register set. The
general location of the registers in the I/O space of the PC is determined by the base address
selection, whereas the specific location of the registers within the register set is determined by
the AT-MIO-64F-5 decode circuitry. Figure 2-1 shows the parts locator diagram of the
AT-MIO-64F-5 board.
Содержание AT-MIO-64F-5
