NAPCO LIBRA LIB-P432EX, Инструкция по программированию

Страница: 19 / 68

NAPCO Security Systems LIBRA LIB-P432EX Series Programming Instructions
Page 19
Dealer Code
Directly enter the Dealer Code, including leading zeros. Use the
1
through
9
buttons.
NOTE: Press
0
for a zero. Press
u
to save.
Re-enter the Dealer Code to verify the previous code. Press
u
to save. Press NEXT ("
r
" or
p ) to proceed. NOTE: The Dealer Code can be two or more digits (up to 6 digits).
CLEAR PROGRAM:
Should it be necessary to create a new custom default program, (a) from the Dealer Program Mode, press
y
to enter the Address Program Mode; (b) access Location 2285 (Clear Program) or 2286 (Cold Start); (c) press
u
and then
(d) press
y
to exit the Dealer Program Mode. A System Trouble Condition will occur. Press
y
to silence the keypad.
(Direct Entry)
33
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
INTERIOR BYPASS FIRE/TBL SYS TBL CHIME
rE
ZONE DESCRIPTIONS: GEM-DXK3 or GEM-DXRP3 cannot be used to enter Zone Descriptions. To enter Zone Descriptions, you must use
the GEM-DXK1 or GEM-DXRP1 keypad or the Napco Quickloader Software.
DATE ENTRY: GEM-DXK3 or GEM-DXRP3 cannot be used to enter the date. To enter Date, you must use the GEM-DXK1 or GEM-DXRP1
keypad (Version 5 or later) or the Napco Quickloader Software.
TIME ENTRY: GEM-DXK3 or GEM-DXRP3 cannot be used to enter the time. To enter Time, you must use the GEM-DXK1 or GEM-DXRP1
keypad (Version 5 or later) or the Napco Quickloader Software.
EXIT DEALER PROGRAM MODE: This completes the custom default program. Press
y
to enter the Direct Address
Program Mode for further programming or press
y
once again to end all programming and resume normal keypad operation.