NAiS GT10, Техническое руководство

Страница: 46 / 195

GT10/GT30 2.3 Wiring the COM. Port
23
2.3 Wiring the COM. Port
Accessory communication connector/applicable wiring
The communication connector used for the COM. port (provided as an accessory with
the main unit) has a screw–tightening type of terminal base. The wiring shown below
should be used.
Accessory communication connector
The communication connector is made by Fenics Contact Co., Ltd.
Fenics Model No.
No. of pins
Model No. Product No.
5–pin MC1, 5/5–ST–3,5 1840396
Applicable wiring (twisted wiring)
Size Conductor Cross–Section Surface Area
AGW#28 to 16 0.08 mm
2
to 1.25 mm
2
Applicable stick–type terminals with insulated sleeves
If stick–type terminals are used, the models listed below are marketed by Fenics
Contact Co., Ltd.
Maker Cross–Section Surface Size Fenics Co. Model
0.25 mm
2
AGW#24 AI 0,25 to 6 YE
Fenics Contact
0.50 mm
2
AGW#20 AI 0,50 to 6 WH
Fenics Contact
Co., Ltd.
0.75 mm
2
AGW#18 AI 0,75 to 6 GY
1.00 mm
2
AGW#18 AI 1 to 6 RD
Crimp tools for stick–type terminals
Fenics Model No.
Maker
Model No. Product No.
Fenics Contact Co., Ltd. CRIMPFOX UD6 1204436
Use a special tool to tighten the terminal base of the communication connector
Tightening of terminals should be done using a screwdriver made by Fenics Contact
Co., Ltd. (Fenics mfg. no. 1205037, blade width 0.4 x 2.5, model no. SZS 0.4 x 2.5), or
a screwdriver made by Matsushita Electric Works Co., Ltd. (Product number AFP0806).
The tightening torque should be 0.22 N
·
m to 0.25 N
·
m or less.