NAiS GT10, Техническое руководство

Страница: 127 / 195

GT10/GT30 6.2 Entering Configuration Settings with GTWIN
104
If “On” is set for the above Auto–Off backlight feature, clicking on the button displays
a screen where the time until the backlight goes off can be specified. Any time from one
minute to 30 minutes can be specified.
KEY POINTS
If the backlight is turned off automatically using the backlight control
function, touching the screen turns it on again. If a touch switch
happens to be located at that point on the screen, it will be invalid until
the backlight has gone on again.
Touch Sounds
This sets the touch sounds corresponding to GT30 screens as either invalid or valid.
Select one of the radio buttons.
Disable ––– Touch sounds are disabled.
Enable ––– Touch sounds are enabled.
Dead battery display
This specifies whether or not a dead battery mark will be displayed on the GT30 screen
if the voltage of the internal battery drops too low.
Don’t display ––– The dead battery mark is not displayed.
Display ––– The dead battery mark is displayed.
6.2.7 GT Configuration Settings: “Hold PLC Device”
Clicking on the “Hold PLC Device” tab in the “GT Configuration” dialog box displays the
screen shown below. “Hold PLC Device” is a function that enables internal PLC device
values to be held on the GT30 side.
“Hold PLC Device” screen