© Ernst Nagel GmbH 2S Trimmer Service Manual en.doc Rev.1.0. 20.07.2011
95
Contents
6. Default / basic adjustments
(continued)
6.2 Adjusting booklet quality
(continued)
6.2.2 Side Trim (Finished Size)
Before making adjustments to the STR, make sure that the fault/error is not present in previous
machines
.
Use their Service Manual to perform a Paper Size Check.
Fig.
6.17
Fig.
6.18
Fig.
6.19
Fig.
6.20
Adjusting
No.
Action
Remarks
1
Make a booklet without Side Trim.
2
Measure if the size of the booklet is conform the Size displayed
on the UI.
If not, adjust the BM.
(See Fig. 6.17 & 6.18)
3
Use the ‘
▲
/
▼
’ and the ‘
+ / -
‘ buttons to select and adjust the
Side Trim / ‘Finished Size’ (e.g. 287.0mm) and press the ‘Enter’
button.
(See Fig. 6.19 & 6.20)
4
Make a booklet with Side Trim.
5
Measure if the Finished Size of the booklet after trimming is
conform the Size displayed on the UI.
(See Fig. 6.20)
6
If the measured Finished Size is the same as UI-Finished Size the
adjustment is complete.
If not, adjusting the NVM Values by continue chapter:
8.2 Adjusting NVM Values
