© Ernst Nagel GmbH 2S Trimmer Service Manual en.doc Rev.1.0. 20.07.2011
100
Contents
6. Default / basic adjustments
(continued)
6.3 Sensors and Switches
(continued)
6.3.2 Adjusting Photo Sensors
(continued)
Fig.
6.28
Fig.
6.29
Fig. 6.30
Adjusting FC1, FC2 and FC3
No. Action
Remarks
1
Open the Top Cover.
2
Place an unprinted paper (sheet) in front of Infeed and turn the
belts to insert the paper into the STR until it lies under one of the
Photo sensor (FC1or FC2 or FC3).
(See Fig. 6.28 & 6.29)
3
Use a small screw driver to adjust the sensitivity of the Photo
sensor until the light on top lights up.
(See Fig. 6.30)
4
When the Photo sensor lights up, the paper is in his range.
After that adjust the Photo sensor one stripe further than it was
adjusted in step No. 3.
It turns off when the paper is removed.
