4
Mounting and installation
Inserting a Micro-SD card
18
V5.20170221
31302713-02-EN
▪ enable communication with other ISOBUS components.
You will need a different connection cable for this, depending on the model of your tractor.
▪ In tractors that have been retroactively upgraded with an ISOBUS basic vehicle harness
manufactured by Müller-Elektronik, use connector cable A from the ISOBUS basic vehicle
harness.
▪ In tractors that are equipped as standard with ISOBUS and that have an ISOBUS in-cab
connector, you will need the following connector cable:
Sub-D <-> CPC connector cable, item no. 30322541
When there is more than one terminal in the tractor cab, you may need to change certain settings in
order to enable two-way communication. Find out more: Using two terminals [
1.
Connect the 9-pin plug A of the basic vehicle harness to the CAN port of the terminal.
2.
Tighten the safety screws on the connector.
Inserting a Micro-SD card
The micro-SD card serves as internal storage for the terminal.
To change the SD card:
1.
Switch off the terminal and disconnect all cable connections.
2.
Unscrew the cover on the rear of the terminal.
3.
Use your finger to press on the SD card in the slot.
⇨
The SD card is unlocked and now protrudes by approx. 1 mm.
4.
You can remove the card.
5.
To lock the card again, press the card lightly into the slot until it is locked again.
6.
Screw the cover back onto the rear of the terminal.
Using two terminals
The following table will tell you which settings you need to configure to be able to use two terminals,
and the chapters in which these are described. The specifications on the in-cab terminals are without
liability.
Settings for TRACK-Guide and the in-cab terminal
Possible purpose
TRACK-Guide settings
Setting of the in-cab terminal
TRACK-Leader and SECTION-Control on
the ME terminal.
Operation of the job computer on the in-
cab terminal.
Login as ISOBUS terminal: No [
Activate the ISOBUS terminal (JohnDeere:
Implement Bus; Fendt: Fendt ISOBUS
terminal).
Deactivate Task Controller (JohnDeere:
Task Controller; Fendt: Taskcontroller).
TRACK-Leader, SECTION-Control, and
Login as ISOBUS terminal: Yes [
Deactivate the ISOBUS terminal
Procedure
4.4
Procedure
4.5
