MTech MA-1000, Руководство по установке и эксплуатации

Страница: 75 / 107

74
2.2.7 Configuring Device Output Settings
To configure the output settings of a device, left click on the device and then select Device Outputs .
The screen shown below in
FIGURE 11
will then appear: -
FIGURE 11 - Device Output Settings
For a multi-output device, the output number can be changed at the top of the window, to allow settings to be
defined for each individual output.
1. Each output can be trigger by:
Address
– Any point address from the list (allocated devices) up to 16 may be chosen.
Zone
– Any zone from the list (allocated devices) up to 16 may be chosen.
Global
– Any address or zone will trigger the output.
2. Double-knock
– Any two devices from the allocated list, when the two devices from the
list enter an Alarm condition, the chosen output will enable. For the Global settings any 2
devices in alarm condition.
MCP Override
– When any manual pull from the allocated list will trigger the chosen
output will enable even in an X-cross situation.
3. Delay time - from 1 to 10 minutes.
Additional setting for the loop sounders.
Sounder Volume : low, medium or high
Sounder Tone: Continuous , Two tone, Slow whoop.