MTech MA-1000, Руководство по установке и эксплуатации

Страница: 104 / 107

103
Appendix 4.11
Operating Instructions MA-1000 Fire Alarm Control Panel
The Built in Keypad
The keypad is built into the system it has a two-line (16 Characters each line) LCD
display which provides easy to read readouts. The MA-1000 has 15 digit keys, as well as Esc, Enter keys:
Local Service Representative
Name:
Address:
Phone:
This document must be framed and mounted in
view adjacent to the FACP
For maintenance recommendations refer to the MA-1000
Installation & Operations Manual Doc# 900297 09-09-2007 & NFPA
72: National Fire Alarm Code®, 2007
Document#900297 Rev.A -05-2012
NORMAL
- Only
AC POWER
is illuminated green.
All other indicators are off. LCD display will read SYSTEM
ALL NORMAL.
AC
ALARM
TROUBLE
SILENCE
SUPERVISORY
PANEL KEY
- The key to open the panel can be found at the following
location:_________________________________________________
WHEN AUDIBLE DEVICES ARE SOUNDING -
FOR AN ALARM
1. Evacuate the protected area
2. Notify the monitoring service and/or the Fire Department immediately. Tell them briefly what happened and what
your current status is.
Phones: ____________________________ _________________________________
Fire Department Monitoring Service
3. If the Fire Department is responding, be prepared to provide directions to arriving firefighters.
FOR TROUBLE ONLY
1. Notify the monitoring service and/or Fire department if this panel is connected to either one, and tell them
what is happening.
2. Silence audible devices by unlocking and opening the panel and pressing the YELLOW SILENCE button. The
TROUBLE indicator will remain illuminated yellow. Contact authorized service personnel immediately! (See Below).
WARNING!
DO NOT ALLOW TROUBLE CONDITIONS TO REMAIN LOGGED IN THE SYSTEM.
THE PROTECTION THE SYSTEM OFFERS HAS BEEN COMPROMISED, OR ELIMINATED WHEN A
TROUBLE CONDITION EXISTS.
To return to normal after an alarm
1. Do not enter the protected area until safe to do so.
2. Clear all initiating devices. Smoke detectors will not reset
if there is still smoke in the area.
3. Reset the control panel (PRESS the RED RESET button)
Power failure or brownout
If AC power drops too low or fails, the AC POWER indicator will
go off, the system the TROUBLE indicator will turn on yellow, and
the panel buzzer and any other audible trouble devices will sound.
Contact authorized service personnel immediately. See local
service representative below .
Alarm Silencing
Notification Appliance Circuits may be silenced by pressing the
YELLOW SILENCE button.
ALARM SILENCED
will turn on yellow.
Subsequent alarms will reactivate circuits. Press the RESET
button to clear the "silenced" condition.
NOTE: Notification Appliance Circuits may be programmed as
nonsilenceable.