MPC NetFRAME 1420, Техническое справочное руководство

Страница: 35 / 120

MPC Computers, LLC NetFRAME 1420
4. Power up the system and check that the fan is working properly and that the LED on the
control panel has turned off. Finish by replacing the chassis cover.
Drive Bays
Warning: Power down the system before installing or removing CD-ROM,
floppy, or IDE drives.
Accessing the Drive Bays
Serial ATA Drives:
Because of their hot-swap capability, you do not need to access the inside of
the chassis or power down the system to install or replace Serial ATA drives. Proceed to the next
step for instructions.
CD-ROM/Floppy Disk Drives:
For installing/removing a CD-ROM or floppy disk drive, you will
need to gain access to the inside of the system by removing the top cover of the chassis.
Note: Only a "slim" CD-ROM drive will fit into this system.
Serial ATA Drive Installation
1. Mounting a Serial ATA drive in a drive carrier
The Serial ATA drives are mounted in drive carriers to simplify their installation and removal from
the chassis. These carriers also help promote proper airflow for the Serial ATA drive bays. For
this reason, even empty carriers without Serial ATA drives installed must remain in the chassis.
To add a new Serial ATA drive, install a drive into the carrier with the printed circuit board side
toward the carrier so that the mounting holes align with those in the carrier. Secure the drive to
the carrier with four screws, as shown in the figure below.
Mounting a Drive in a Carrier