Motorola SC 300, Руководство по установке

Страница: 86 / 96

Attaching the Mounting Bracket to a Pole
– continued
DRAFT
SC 300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
3-10
Procedure to Attach the
Mounting Bracket to a Pole
Follow the procedure in Table 3-5 to attach the mounting bracket to a
pole.
Table 3-5: Procedure to Attach the Mounting Bracket to a Pole
Step Action
1 Verify that the isolator pads are in place on the bracket.
5 Verify the safety of the installation location.
6 Place the bucklestrap through the channel clamp as shown in Figure 3-3.
7 Place the channel clamp and bucklestrap on the pole approximately where the upper portion of the
BTS is to be located. See Figure 3-3.
8 Slide and center the upper channel extrusion on the channel clamp. See Figure 3-3.
9 Wrap the bucklestrap around the pole and through the fitting on the end of the band. Pull the
band until it is makes concentric contact with the pole.
10 Start but do not tighten the lower channel extrusion to the mounting bracket. Use 2 M6x19
tamper–resistant screws.
11 Before you tighten the lower strap, attach the mounting bracket to the top channel extrusion.
12 Slide the bucklestrap through the channel clamp and slide the channel clamp on the lower channel
extrusion. Wrap the bucklestrap around the pole and through the fitting.
13 Secure the bucklestrap with the bucklestrap tool. Refer to the instructions included with the
bucklestrap tool.
14 Use a T30 Torx tamper bit to tighten the six M6x19 screws to 5.0 N–m.
15 Center the channel clamp on to the lower extrusion.
16 Place the bucklestrap through the lower channel clamp.
17 Use the bucklestrap tool to secure the lower strap.
3