Motorola RS507 Series, Руководство по продукции

Страница: 31 / 263

1 - 16 RS507 Hands-Free Imager Product Reference Guide
When using the application on your mobile computer in “Pick List” mode, the Bright Center Dot can be positioned
anywhere on the symbol (see
Figure 1-15 ).The top examples in Figure 1-17 show acceptable aiming options, while
the bottom examples can not be decoded.
Figure 1-17
Acceptable Aiming Options
The aiming pattern is smaller when the Imager is closer to the symbol and larger when it is farther from the symbol.
Scan symbols with smaller bars or elements (mil size) closer to the Imager and those with larger bars or elements
(mil size) farther from the Imager.
1.
Hold the Imager between two and eleven inches from the bar code (depending on the bar code density).
2.
Press the Scan trigger. The aiming pattern illuminates red indicating that the laser is on. One green flash of the
Scan LED and a high beep indicates that a bar code was properly decoded.
Customize the Imager
Changing from Triggered to Triggerless Configuration
To change from Triggered to Triggerless configuration:
1.
Remove the Comfort Pad (see Comfort Pad Replacement on page 3-3 ).
2.
Remove the Trigger Swivel Assembly (see Trigger Swivel Assembly Replacement on page 3-4 ).
3.
Install the Triggerless Strap Holder (see Triggerless Strap Holder Replacement on page 3-6 ).
4.
Install the Comfort Pad (see Comfort Pad Replacement on page 3-3 ).
5.
Perform a cold boot (see Cold Boot on page 1-17 ).
0 1 2 3 4 5
0 1 2 3 4 5
0 1 2 3 4 5
0 1 2 3 4 5
NOTE
When a symbol is under transparent plastic or on a mobile computer screen, it is recommended to use a
tilt (pitch) or skew scan angle to minimize reflection.