28
3 Getting
Started
3.1
For Your Safety
WARNING:
Use extreme care when installing antennas near power lines.
WARNING:
Use extreme care when working at heights.
WARNING:
The Outdoor Unit (ODU) for the PTP 600 Series Bridge must be properly
grounded to protect against lightning. It is the user’s responsibility to install the equipment in
accordance with Section 810 of the National Electric Code, ANSI/NFPA No.70-1984 or
Section 54 of the Canadian Electrical Code. These codes describe correct installation
procedures for grounding the outdoor unit, mast, lead-in wire and discharge unit, size of
grounding conductors and connection requirements for grounding electrodes. It is
recommended that installation of the outdoor unit be contracted to a professional installer.
WARNING:
The ODU for the PTP 600 Series Bridge must be grounded to a Protective Earth
as described in Section
960H
5.7.6 ”
961H
Grounding The Installation” of this Installation Manual and in
accordance with the Local Electrical Regulations.
WARNING:
It is recommended that the supplied Power Indoor Plus (PIDU Plus) – PTP 600
Series is used to power the PTP 600 Series Bridge ODU. The use of other power sources
may invalidate safety approval and affect your warranty.
WARNING:
When using alternate DC supplies (via the PIDU Plus DC in terminals as
described in Section
962H
1.3.3 “
963H
Redundancy and Alternate Powering Configurations”), such as
battery-backed DC power source, the supply MUST comply with the following requirements:
•
The voltage and polarity is correct and is applied to the correct terminals in the PIDU Plus
•
The power source is rated as SELV
•
The power source is rated to supply at least 1A continuously, and
•
The power source cannot provide more than the Energy Hazard Limit as defined by
IEC/EN/UL6090, Clause 2.5, Limited Power (The Energy Hazard Limit is 240VA)
CAUTION:
Users and installers should note that the main power supply is the primary
disconnect device.
Содержание MOTOWI 4 PTP 600 Series
