249
19.3 National and Regional Regulatory Notices – 5.4 GHz Variant
19.3.1 U.S. Federal Communication Commission (FCC) and Industry Canada (IC) Notification
28F
29
This device complies with part 15.407 of the US FCC Rules and Regulations and with RSS-
210 Issue 7 of Industry Canada. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation. In Canada, users should
be cautioned to take note that high power radars are allocated as primary users (meaning
they have priority) of 5250 – 5350 MHz and 5650 – 5850 MHz and these radars could cause
interference and/or damage to license-exempt local area networks (LELAN).
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15E of the US FCC Rules and with RSS-210 Issue 7 of Industry
Canada. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate
radio-frequency energy and, if not installed and used in accordance with these instructions,
may cause harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to correct the interference by one or more of
the following measures:
•
Increase the separation between the affected equipment and the unit;
•
Connect the affected equipment to a power outlet on a different circuit from that which the
receiver is connected to;
•
Consult the dealer and/or experienced radio/TV technician for help.
•
FCC IDs and Industry Canada Certification Numbers are listed in
1249H
Table 35
Table 35 - US FCC IDs and Industry Canada certification numbers
29
FCC and IC certification approval applies ONLY to INTEGRATED variant.
Содержание MOTOWI 4 PTP 600 Series
