Motak PKM0335, Руководство по обслуживанию

Страница: 18 / 132

18 Part Number: 000016427 Rev 00 08/2020
Requirements - Cleaning - Operation
Step 1 Remove/open the front door to access the evaporator compartment. Ice must
not be on the evaporator during the descaling and sanitizing cycle. Set the toggle switch to
the OFF position after ice falls from the evaporator at the end of a harvest cycle. Or, set the
switch to OFF and allow the ice to melt off the evaporator
,
Caution
Never use anything to force ice from the evaporator. Damage may result.
Step 2 Remove all ice from the bin.
n
Warning
Wear rubber gloves and safety goggles (and/or face shield) when handling Ice Machine
Descaler/Cleaner or Sanitizer.
,
Caution
Do not mix Ice Machine Cleaner/Descaler and Sanitizer solutions together. It is a
violation of Federal law to use these solutions in a manner inconsistent with their
labeling.
Step 3 Place the toggle switch in the CLEAN or WASH position. Water will flow through
the water dump valve and down the drain. Wait until the water trough refills, then add the
proper amount of ice machine cleaner/descaler.
Model Amount of Cleaner/Descaler
PKU0155 2 ounces (60 ml)
PKM0335/PKM0425/PKM0535 5 ounces (150 ml)
Step 4
Wait until the cycle is complete, then place the toggle switch in the off position
and disconnect power and water supplies to the ice machine (and dispenser when used).
Step 5
Remove parts for descaling.
Refer to the proper parts removal for your machine. Continue with Step 6 when the
parts have been removed. Refer to “PKM0335/PKM0425/PKM0535 Parts Removal” on
page 20 or “PKU0155 Parts Removal” on page 21.
Step 6
Mix a solution of cleaner/descaler and lukewarm water. Depending on the
amount of mineral buildup, a larger quantity of solution may be required. Use the ratio in
the table below to mix enough solution to thoroughly clean all parts.
Solution Type Water Mixed with
Cleaner/Descaler 1 gal. (4 l) 16 oz (500 ml) cleaner/descaler