SECTION 2
Loading Paper
Figure 2-2
❶
Remove the outer packaging from the paper stack.
❷
Facing the front of the device, use the release latch on the left side and slide the paper tray cover to the left.
❸
Place the stack of thermal paper into the paper tray such that the grid side of the paper is up when it is pulled
over the paper tray cover. The paper cue mark (a small black rectangle) should be in the lower left corner.
❹
Manually advance one page of paper beyond the closure point of the writer. Make sure the paper lays on
the black roller evenly within the channel of the paper door. If paper is not manually advanced evenly, risk
of jamming or queue faults increases.
➎
Slide writer cover to the right until the cover latches in a locked position. You will hear a sharp click
when the door is properly latched.
WARNING:
Risk of injury to fingers in writer paper door or platen drive mechanisms.
NOTE:
For proper performance of thermal writer, be certain to use Mortara recommended
thermal paper.
10
Содержание ELI 150 Rx
