MORLEY-IAS
ZX2E/ZX5E Fire Alarm Control Panels
Page 4 of 28
Document No. 996-130, Revision: 01,
User Manual
1 Introduction
1.1 Notice
•
The material and instructions covered in this manual have been carefully checked for accuracy and are
presumed to be correct. However, the manufacturer assumes no responsibility for inaccuracies and
reserves the right to modify and revise this document without notice.
•
These instructions cover the use and operation of the Fire Alarm Control
Panel. Refer to the Installation Manual (P/N 996-131) for details of how to
install the system and refer to the Commissioning Manual (P/N 996-132) for
information on programming and Level 3 functions.
•
The ZX1E, ZX2E and ZX5E Fire Alarm Control Panels are 1, 1-2 and 1-5 loop panels for use with
analogue addressable devices from the following detector manufacturer ranges: -
Apollo
S90
Hochiki
Morley-IAS
Nittan
System Sensor
1.2 Warnings and Cautions
These instructions contain procedures to follow in order to avoid injury and damage to
equipment. It is assumed that the user of this manual has been suitably trained and is
familiar with the relevant regulations.
All equipment is to be operated in accordance with the appropriate standards applicable
1.3 National
Approvals
This equipment must be installed and operated in accordance with these instructions and the
appropriate national, regional and local regulations specific to the country and location of the
installation. Consult with the appropriate Authority Having Jurisdiction (AHJ) for confirmation of the
requirements.
For use with software
version 800 onwards