Morita AdvErL EVO, Инструкция по эксплуатации, Страница: 54 / 76

Instructions for Use 2018-10-22 52
6. Maintenance, Inspection and Calibration
•
The equipment must not be taken apart by anyone except for specially trained MORITA service
personnel. High voltage circuits inside the unit could cause death by electric shock. For
disassembly and servicing, rely only on J. MORITA OFFICE personnel.
• Check laser output annually.
• A laser beam could be emitted if the top is removed and the safety interlocks are disabled. Never look
into the aperture where the laser comes out or touch it.
Annual Maintenance
* The AdvErL EVO should be maintained annually in accordance with the following maintenance and
inspection items.
Maintenance should be done by specially trained service personnel.
1) Outline
•
Screw Tightness of all screws, bolts etc.
•
Floor level and casters are stable
•
Main Power Supply Within: 100 V to 240 V ±10%
•
Electric Circuits wiring and Cables for foot switch and power.
2) Function check (Interlock)
•
Emergency Stop
•
Hollow Waveguide disconnected.
•
Remote Interlock connector disconnected.
•
Interlock messages are not displayed before use
•
Foot Switch
•
Key Switch
•
Spray Water
•
Tip Air
3) Replacement
•
Cooing water and Deionization Filter Cartridge
Replace all the cooling water and deionization filter cartridge.
•
Flash Lamp
Check flash lamp usage. Replace after 10 million shots.(recommend)
4) Other Parts
•
Aiming beam emission
•
Laser Safety Glasses are not damaged.
•
Tips are not damaged or dirty.
•
Handpiece O-ring
•
Handpiece is securely attached
5) Calibration of Laser Output
•
Laser Output Level
Output level is ± 20 % of displayed value.
Calibration is to be performed only by a trained service engineer.
* For repair or other types of service contact your local dealer or J. MORITA OFFICE.
* Contact your local dealer or J. MORITA OFFICE for repairs.
* High voltage circuits are inside the unit; do not try to perform servicing or adjustments yourself.