Morgana AutoCreaser Pro 50, Руководство по обслуживанию

Страница: 8 / 40

Page 8
CREASING
VACUUM DRUM FEED BELT REMOVAL / REPLACEMENT.
Drum Drive Belt replacement.
1.Following stages 1 to 6 above, the belt can be removed from the vacuum drum.
2.Remove the slot sensor from the motor mounting bracket.
3.The belt can now be removed from the machine.
Replacement is the reverse procedure.
To tension the belt loosen the three screws fixing the bracket to the feed table,
adjust the tension to allow a quarter of a twist along its run and retighten the cap head screws.
Replacing the drive motor or sensor.
1.Remove the Compressor cover below the feed bed and the rear cover
2.Remove the top stainless steel feed bed.
3.Remove the moving side guide.
4.Unplug the motor or the sensor from the respective PCB at the rear of the machine
and feed the wire up through the access holes.
5.Unscrew the motor or the sensor from the motor mounting bracket and remove.
Replacement is the reverse procedure.
To tension the belt loosen the three screws fixing the bracket to the feed table,
adjust the tension to allow a quarter of a twist along its run and retighten the cap head screws.
Note. care should be taken not to over tighten the slot sensor as it is plastic.
FIG.2.2
M5 Socket
Screw
Bearings
and Shims
Center
Support
Plate
Feed Belt