Morgana AutoCreaser Pro 50, Руководство по обслуживанию

Страница: 16 / 40

Page 16
CREASING
SECTION 6
REMOVAL/REPLACEMENT OF TOP INFEED ROLLLER
REMOVAL/REPLACEMENT OF BOTTOM INFEED ROLLLER
6.1 With the unit on a bench
6.2 Remove the drive belt and flanged pulley from the bottom infeed roller.
6.3 Viewing on the outside of the sideplate, align the lug on the eccentric
with cutout in the sideplate.
6.4 Using a soft mallet gently tap the roller assembly from the opposite
side supporting its length as it emerges.
6.5 Remove the drive belt and top infeed roller assembly and the bottom
flanged pulley as above.
6.6 Remove the cap head screw from the rear of the roller shaft, and then remove the
pulley.
6.7 Gently tap the roller from the rear, this will extract the outer race of the needle
bearing from the front side plate.
6.8 The roller can now be withdrawn inwards through the mechanism.
6.9 Remove the bearing retaining screw on the inside of the rear side plate, the deep
grooved ball race can now be extracted.