AutoCreaser Pro 33A
Replacing Creasing Blade Set
4.
Swing the bridge assembly up (3) & then Lift out (4) (Fig. 11)
3.
Lift Out Blade Set (Fig.12)
4. Slide the new blade set into the brass blade guides & refit the bridge assembly, this is a
reverse of removing the blade.
4
3
FIG. 4
FIG. 11
FIG. 12
Page 36
CREASING
The Blade Assembly
NOTE.
The blade set can be fitted with the ANVIL at the bottom or with the ANVIL at the top.
The blade set is supplied from the factory with the ANVIL at the bottom as shown in Fig13.
The blade set can be changed to have the ANVIL at the top (as shown in Fig. 14), this can
improve the repeatability of the fold relative to the crease for certain fold types or when
using lighter stocks.
11. Push the exit guard down and replace the stacker assembly before operating the
machine.
12. Switch the machine on and test the crease for form, If the pressure and the alignment
of the crease is not to a satisfactory level, see pages 33 to adjust the creasing line.
‘Spares’ kits
In the event of any damaged or lost components within the blade assembly, spares kits
are available on request. However, components within the blade set can not be ordered
separately ie single blade or anvil.
The following Blade sets are supplied with the Autocreaser Pro 33A as standard.
Standard Blade set Part number 76-07-01
Consisting of a standard blade and anvil, blade brushes, blade links and alignment bolts
.
When running lighter stocks it is recommended that an Narrow Blade Set is used,
this can be purchased from Morgana Systems Ltd, Part number 76-07-02.
FIG. 13
FIG. 14
`
Page 37
SYSTEM
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
