Page 8
CREASING
Quick Start Guide
Setting the machine to operate in automatic sheet feed mode
1.
Set the gap between the paper gate and the vacuum roller to approximately twice
the thickness of the stock to be creased.
2.
Place the stock to be creased onto the loading table against the fixed side lay.
3.
Release the clamps on the adjustable side lay and slide up to the paper stack
allowing a gap of approximately 0.5mm (1/64 inch) between the paper and the side
lay.
4.
Position the backstop and slide it up to the paper stack, also allowing a gap (as
stated in the above step).
5.
Turn the Emergency Stop button clockwise to switch the power on. After the
system start up procedure the touch screen will be displayed as shown below.
WARNING:-
Wait at least 10 seconds, after making any selection on the Touchscreen
panel, before switching the machine OFF. Failure to do so could result in the
data storage being corrupted, and the machine not operating.
IMPORTANT.
If you have not been trained to operate this machine, we strongly advise that you select
the red cross icon.
We recommend that you either seek training or ask a trained operator to run the machine
for you.
Select the green tick icon only if you have been trained to operate this machine.
If you have not been trained to operate this machine and you select the green tick icon,
Morgana Systems Ltd accept no responsibility for personal injury, damage to the
machine or damage to materials being processed by the machine.
Page 9
SYSTEM
Quick Start Guide
AutoCreaser Pro 33A
The touch screen is laid out into 3 main areas as shown below:
Settings Pages.
Paper Settings Page.
Status of
machine &
data entry
area. Also
used for
quick links
to setting
pages.
Tabs to enable switching between setting
pages - choose either Paper Settings,
Crease Setting, Store or Tools
Setting
page
Batch Button - Image
is identical to that
shown in the status
area. On selection the
status area is replaced
with a calculator for
inputting new values.
Batches of any
numerical value.
Fold Selection - For quick setting of crease positions on standard size sheets.
Highlighted fold is type currently selected, other folds may be selected.
Currently selected fold is shown in the status area.
Page Length - On
selection the status
area is replaced with
a calculator for
inputting new values.
Min Length = 190mm
Vacuum Suck - There
are two selections
available - 1 short
suck & 2 continuous
for stream feeding.
Highlighted number is
type currently
selected. The status
area also shows
currently selected
suck.
Arrows may be
selected to increase
or decrease the page
size in 0.1mm
increments
Toggle between, Delay between batches
and stop after batch
Current Job Name
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
